Bison Epoxy Metal Blister 24ml

Bison Epoxy Metal Blister 24 ml (BIS-6305442)

• Extreme strength: up to 220 kg/cm²
• Metal colored
• Resistant to harsh conditions
• Resistant to temperatures between -40°C and +100°C
• (Sea)water resistant
• Very good chemical resistance
• Can be sanded, filed, drilled and painted after curing

Instructions to Use:

• Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a synthetic spatula until a mixture is obtained with a homogeneous color. Apply the mixture, which at room temperature (+20°C) remains tool able for about 45 minutes, as a thin layer on one of the two materials. Join the materials and keep them in place for 10 hours. Be careful not to move the parts before the adhesive has cured. After use, clean the nozzle with a cloth and place the special cap in the handle on the double syringe. Resin and hardener must not come into contact with each other unless for usage.
• Points of attention: After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance, it is important to create a larger amount of adhesive and mix it very well. Curing time depends on temperature. The adhesive does not cure below +5°C.

Storage conditions:

Store cool, dry, frost-free, upright (nozzle upwards) and tightly closed.