Johnsen's R134A Quick Charge Kit - Imported From Usa

Johnsen's R-134A Quick Charge Kit Plastic

• Designed for easy recharging of R-134a A/C systems using 12oz. cans.
• Contains a dispending valve. Hose and low side quick coupler.
• Plastic

Direction for use :

• Turn the valve handle of the charging kit counterclockwise until the piercing stem is in the up position.
• This will prevent piercing the R-134a can.
• Screw the low side service port on the A/C system.
• Locate the low side service port on the A/C system.
• Remove the cap from the low side service port.
• Attach quick connect fitting to the service port by pulling the connector ring back as you push it onto the service port.
• Make sure the fitting is tight.
• Start the engine and set A/C system control to max A/C.
• Turn the valve handles counterclockwise until you can hear the refrigerant leaving the can.
• While charging, rotate the can between 12 o'clock and 3 o'clock every 2 to 3 seconds while continuously agitating (shaking) the can back and forth.
• Continue this process until the can is empty(5 to 15 minutes) or until the correct amount of refrigerant is charged into the A/C system.
• When the can feels empty, hold it upside down for one minute to remove all refrigerants.
• Charge the R-134a A/C system per OEM specifications.
• Remove quick connect fitting by pulling back on the connector ring and then pulling it off the service port.
• Remove the can from the charging kit and discard it.

Note :

Always store the charging kit with the piercing valve in the up position. This prevents piercing or the next can.

Caution :

Always use protective eyewear. Read labels on the refrigerant can before using this product.