Bigred Aluminum Steel Round Jack Stand With Safe Pin 3 ton – Chrome + Red

 Jack Stands are designed to support rated capacity, partial vehicle loads consisting of one end of a vehicle. Use both stands for each operation.

• Large area feet resist sinking into the asphalt and provide a sturdy stance.
• Foam bumper on the handle to prevent damage to vehicle finish.
• Steel construction
• oversized, cast aluminum base
• 5-hole fit is secure with a locking bearing
• Includes 2 Jack Brackets

Direction for use :

In order to prevent removal of the post from the base use a hammer and flat end punch to hammer the jack's tab in toward to post but not touching the post. The same stands are equipped with a bolt instead of the tab. In this case, the bolt can be threaded in toward the post until the bolt bottoms out.

• Use on a hard level surface with less than 3 degrees of slope.
• Raise the vehicle with a suitable jack
• Adjust the height by pulling up on the ratchet bar.
• The weight of the locking handle should secure the ratchet bar in the desired position. To confirm this, simply push down on the locking handle. Check to ensure ratchet is secure before loading.
• Carefully position jack stands so that load is centered on stand's saddle.
• Slowly lower the vehicle onto the stands
• Check to ensure the vehicle is secure before working on, around, or under. When used to support vehicles, use wheel chocks on all unlifted wheels in both directions to prevent inadvertent movement.
• DO NOT jack or Dolley jack stands are supporting the vehicle.

Includes :

• 1 psc Height adjustment extension tube
• 1 psc Post
• 1 psc Base Section
• 1 psc Extension tube support bar
• 1 psc Spring washer M8
• 1 psc Countersunk screw M8X14mm